Plastic materials | idaCut ®
VOTAN C BIM ™
The modern mass production requires the cutting of complex parts with many variations during the production process.
IDASA technology-JENOPTIK Laser suits these needs through its laser cutting without Contact Us allows flexible production of indoor and outdoor.
The cutting of the tail of the car is a good illustration of the advantages of the laser in front of other methods such as milling or punching. No residual particles generated during cutting, so it does not require a post-treatment of the piece, when finished cutting the piece is finished, and this cycle can save time and reduce costs of production.
Advantage
The main advantages offered by the cutting of plastic materials by laser are:
- Extremely good cutting quality
- Seal edges or burrs avoiding waste
- The cut piece does not require treatment after cutting
- Greater flexibility in the changing profile of the pieces cut
In this section (see sub menu):
- Introduction >
- Metallic materials >
- Laser microperforation >
- Ceramic materials >
- Packaging >
© 1986-2010 Ingeniería de Aplicaciones, S.A.
