17/02/2010
NEW APPLICATIONS | Cutting and Welding with Laser

Cutting of bent pipes

The task of creating holes in 3-dimensionally bent pipes requires the application of a fully 3D-capable cutting system. The JENOPTIK-VOTAN C BIM facilitates the creation of such holes, e.g. in vehicle manifolds for the connection of lambda probes. In this way, deformations of the hole geometry caused by the bending process are prevented.

- Contour projection on the pipe surface
- Minimal internal contamination
- Nearly free of burr
- High circularity
- Cutting speed of 75 mm/s

Cutting of Composite - Natural Fiber/Plastic Material

Renewable primary products are increasingly applied in the manufacturing of insulating materials and covering parts, e.g. in motor vehicles. The number one choice for cutting and trimming tasks is the laser cutting machine JENOPTIK-VOTAN C BIM. The integrated catalytic waste gas purification system JENOPTIK-KATASORB perfects the combination of high cutting power and quality on the one hand and ecological harmlessness on the other.

- Free programming
- Material thicknesses of up to 20 mm
- High cutting speeds (>100 mm/s)
- Catalytic pollutant conversion
- Broad range of materials

To enable us to demonstrate the suitability of our laser systems as a tool for processing your products, we cordially invite you to contact with us in order to coordinate a visit at the Customer Application Center in Jena, Germany.

News >

Over these lines:

A left: cutting of bent pipes.
At right: cutting of composite.